Last Modified: 11-29-2007 1.6 A
Service Category: Vehicle Interior Section: Supplemental Restraint Systems
Model Year: 2008 Model: Sequoia Doc ID: RM0000012DQ00AX
Title: SUPPLEMENTAL RESTRAINT SYSTEMS: SEAT POSITION SENSOR: REMOVAL (2008 Sequoia)

REMOVAL

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing SUPPLEMENTAL RESTRAINT SYSTEMS: AIRBAG SYSTEM: PRECAUTION (2008 Sequoia) .

HINT:

Installation is in the reverse order of removal.

The procedure described below is for the LH side.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected INTRODUCTION: REPAIR INSTRUCTION: INITIALIZATION (2008 Sequoia) .

2. REMOVE FRONT SEAT ASSEMBLY LH (for Manual Seat)

(a) Remove the front seat assembly SEAT: FRONT SEAT ASSEMBLY (for Manual Seat): REMOVAL (2008 Sequoia) .

3. REMOVE FRONT SEAT ASSEMBLY LH (for Power Seat)

(a) Remove the front seat assembly SEAT: FRONT SEAT ASSEMBLY (for Power Seat): REMOVAL (2008 Sequoia) .

4. REMOVE FRONT SEAT CUSHION SHIELD (for Manual Seat) SEAT: FRONT SEAT ASSEMBLY (for Manual Seat): DISASSEMBLY (2008 Sequoia)+

5. REMOVE SEAT POSITION AIRBAG SENSOR (for Manual Seat)

(a) Disconnect the connector from the seat position airbag sensor.

(b) Using "TORX" socket wrench T30, remove the "TORX" screw and the seat position airbag sensor.

(c) Remove the seat slide position sensor protector from the seat position airbag sensor.

6. REMOVE SEAT POSITION AIRBAG SENSOR (for Power Seat)

(a) Disconnect the connector from the seat position airbag sensor.

(b) Using "TORX" socket wrench T30, remove the "TORX" screw and the seat position airbag sensor.

(c) Remove the seat slide position sensor protector from the seat position airbag sensor.